PLEASE NOTE: If you had an account with the previous forum, it has been ported to the new Genetry website!
You will need to reset the password to access the new forum. Click Log In → Forgot Password → enter your username or forum email address → click Email Reset Link.
Just wanted to say thank you again Sid and NotMario. Also i adjusted the governor screw to about 62hz no load but the generator still drops the Hz too low under a heavy load. I've heard people complaining about this with Harbor freight generators (read it on a forum a year or two ago), I did some google searches some people are saying 63-64Hz no load (depending on the generator) just wondering if that is or would be safe for the inverter and electronics.
Just wanted to say thank you again Sid and NotMario. Also i adjusted the governor screw to about 62hz no load but the generator still drops the Hz too low under a heavy load. I've heard people complaining about this with Harbor freight generators (read it on a forum a year or two ago), I did some google searches some people are saying 63-64Hz no load (depending on the generator) just wondering if that is or would be safe for the inverter and electronics.
Inverter should electrically be just fine up at 63-64Hz...though you will need to raise the "Hz Trim" setting back to ~60.05Hz or the inverter will drop the AC input due to overfrequency 😉.
Gotta love Harbor Freight stuff. Hey, at least it usually works for a bit 😉.