PLEASE NOTE: If you had an account with the previous forum, it has been ported to the new Genetry website!
You will need to reset the password to access the new forum. Click Log In → Forgot Password → enter your username or forum email address → click Email Reset Link.
I'd actually like an old PJ 8000 that Genetry has previously reworked. I've read those were amazing. Ask Sean to pull one out of the pile.
Comparatively speaking, anyway...
I'm not a sales middleman...you'll need to contact Sean for that 😉.
Haha, i'll fight you for it, Robert!
Really need something not completely garbage for my RV. Sadly, the GS just wont work with the space requirements. (We don't have big RV's in AK)
11 minutes ago, NotMario said:Sadly, the GS just wont work with the space requirements. (We don't have big RV's in AK)
The up-and-coming GS6 are quite a bit smaller than the GS6 you currently have...depends what the dimensions of the space are!
55 minutes ago, NotMario said:Haha, i'll fight you for it, Robert!
Really need something not completely garbage for my RV. Sadly, the GS just wont work with the space requirements. (We don't have big RV's in AK)
I'm not sure why but we're both listed here as collaborators which are "one who willingly cooperates with an enemy, especially an enemy nation occupying one's own country."
I'm not sure why but we're both listed here as collaborators which are "one who willingly cooperates with an enemy, especially an enemy nation occupying one's own country."
That's only if you take the second definition of "collaborator", not the first!
The up-and-coming GS6 are quite a bit smaller than the GS6 you currently have...depends what the dimensions of the space are!
Yeah... 9" Depth x 11" Height x "18" Width.
Boy that would be a tight squeeze if mounted sideways. Considerably complicated by wiring constraints, too.
The other spot, while wide enough with the wings cut off, is about 1/4" too short, and the length would work if the height allowed me to slide it in at an angle.
The width is the biggest no-go on the GS, especially with those wings.
It's a tough set of requirements. My U-Power fits (barely...), but it's not wired for 12 volts, and it's not obvious how that could be done. The tranny is wired for 24->240, so 12->120v is obviously possible, sacrificing the un-needed split phase, but i don't know how i would wire up the control board for that. Heh.
What kind of loads were you running? (Just out of curiosity.)
13.5k 24v lithium battery
Ah, OK...so after repairing the broken wire, you turned it on and the magic smoke came out again.
okay. I'm going to check that board