PLEASE NOTE: If you had an account with the previous forum, it has been ported to the new Genetry website!
You will need to reset the password to access the new forum. Click Log In → Forgot Password → enter your username or forum email address → click Email Reset Link.
Have an old power jack 6000
been great because of az heat started to turn off. So I put a barrel fan in front of it
did great Now it is cooling down
it is shutting down. Never see see stock
internal fan on I need some ideas to help inverter out
thanks
An easy step might be replacing the internal inverter fan with a better one. I have a newer PJ, and it may have a high velocity fan. It sounds like a jet engine, but the inverter stays running even in 116° heat. I am only drawing 500W, though.
Never see see stock
Never see stock internal fan run?
Does your PJ have a little toggle switch on the back? If so, that should be a "fan on." (Fan control on the older PJs was handled by a thermal "clixon" type thermostat--which isn't rated for the DC voltage, and often fails.)
Thanks
looked in front for switch
will check in back
i will see if I can check thermostat
great
An easy step might be replacing the internal inverter fan with a better one. I have a newer PJ, and it may have a high velocity fan. It sounds like a jet engine, but the inverter stays running even in 116° heat. I am only drawing 500W, though.
I will look in to a better fan
thanks for advice